Directions for The Autograph Assistant® for Baseball
  1. Remove both items. Pull apart the Autograph Assistant® - (3 & 9 o’clock). Be careful not to drop the ball.
  2. Remove the protective covers from the ball by twisting them off. Put them in a safe place.
  3. Put the Autograph Assistant® back together with the ball inside it. Line up the tabs (3 & 9 o’clock) and snap it together all the way around.
  4. Remove black bottom handle from bat pen and slide the top of the black handle thru the bottom hole (upwards) towards the top hole of the Autograph Assistant®. Slide it all the way until it snaps and locks in place.
  5. Take the bat pen and start to use it so the ink flows freely. 5 seconds should be good. Do this as close to getting the autograph as possible.
  6. Place bat pen slightly into black handle so it can be removed easily by the signer. If you are going to throw it to a player, then push the pen all the way into the handle. It will be snug now. Hint - To remove pen if tight, twist & pull at the same time.
  7. Spin the ball to the area where you want the autograph signed. Most popular is the “sweet spot”. Push the ball upwards until it locks in place real tight.
  8. Go get your autograph and don't forget to say : THANK YOU!